Instruction Manual | 27
Warning/Information Message Meaning/Recommendations
This folder name is already used. Please select another folder
name.
Results cannot be exported in a folder with an already existing
name.
No data to export. Record data before exporting result.
Impossible to load a .qvir file during measurement. Load feature is disabled during measurement recording.
Measurement aborted because of saturation decrease.
Check the upper slide/drop contact.
Make sure sample platform is in upper position.
The Videodrop detected a saturation decrease during a
measurement. It can be due to the opening of the Videodrop. For
optical safety reason, the measurement has been aborted. Follow
the instruction, and click on Record again.
Measurement aborted.
Sample platform must be in upper position for measurement.
The Videodrop detected a very low saturation value at the
beginning of the measurement. The sample platform is in the
lower position which is hazardous for optical safety and must
be stopped. The measurement has been aborted. Close the
Videodrop, and click on Record again with the handle in the
proper upper position after following the Sample Loading Protocol
in Section 6.1 of this manual.
End of recording.
Maximum number of videos reached.
Measurement ended because the number of video criteria has
been reached.
Recording has been stopped manually. Measurement ended because Stop was clicked.
Please create a new sample to access Adjust saturation. It is not possible to use this feature after exports.
Image processing is in progress.
Please wait…
Waiting message: the software is computing measurement
results.
Images will be deleted.
Do you confirm?
Confirmation requested.
Videodrop closing.
Do you confirm?
Confirmation requested.
Default settings will be restored.
Do you confirm?
Confirmation requested.
These settings will be set as default.
Do you confirm?
Confirmation requested.
Factory settings will be restored.
Do you confirm?
Confirmation requested.
Temperature and viscosity have been modified. When Restore Default or Factory Setting is clicked in the advanced
setting windows, the preselected temperature and viscosity for
the current sample will be modified if they are different from the
defaults or factory values.
The following characters \ / : * ? \” < > | are prohibited. Windows file name rule.
A sample name is required. You must enter a sample name in the Welcome window to create
a new sample.
The sample name exceeds 110 characters. Sample name must use less than 110 characters.
To Next Page
Loading...
