1. Local Basic Operation
⚫ Slight difference may be found on the user interface. The following figures for reference only.
1.12 Getting Started
⚫ This chapter introduces device initial settings such as boot up, device initialization, reset password, and quick
settings.
1.1.1 Boot up
⚫ For device security, connect the NVR to the power adapter first and then connect the device to the power
socket.
⚫ The rated input voltage matches the device power button. Make sure the power wire connection is OK. Then
click the power button.
⚫ Always use the stable current, if necessary, UPS is a best alternative measure. Step 1 Connect the device to the
monitor and then connect a mouse.
⚫ Step 2 Connect power cable.
⚫ Step 3 Click the power button at the front or rear panel and then boot up the device. After device booted up,
the system is in multiple-channel display mode by default.
1.1.2 Device Initialization
⚫ If it is your first time to use the device, set a login password of admin (system default user). You can select to
use unlock pattern to login or not at your own choosing.
⚫ For your device safety, keep your login password of admin well after the initialization steps, and change the
password regularly.
⚫ Step 1 Boot up NVR.
The Device Initialization interface is displayed. See Figure 1-1.
To Next Page
Loading...
