108
6.2.9 File Export (local)
File Export is used to export the data including Running History and
Fault Record to a flashdrive. Press ENT and use UP and DOWN arrows
to export the data, and press ENT to confirm the setting.
6.2.10 Firmware Update (local)
Firmware update is to update the versions of firmware including LCD
Firmware and DPS Firmware. Press ENT and use UP and DOWN arrows
to update the data, and press ENT to confirm the setting. For remote
Firmware updating see section 6.5.
6.3 Power ON/OFF
6.3.1 Manual Power ON/OFF
Restarting the inverter is required after regulation setting or manual (fault)
shut-down. Press ESC or ENT to access the Main Menu. Scroll the curser
down to highlight POWER ON/OFF and press ENT to select. Move the
cursor to “ON” and press ENT to start the inverter. The inverter will start
up and operate normally if the start-up conditions are met. Otherwise, the
inverter will go to stand-by mode.
Normally, it is not necessary to Turn OFF the inverter, but it can be shut
down manually if regulation setting or maintenance is required. Move the
cursor from the main operation interface to POWER ON/OFF and press
ENT. Move the cursor to “OFF” and press ENT, and then the inverter will
be shut down.
NOTICE:
Compatibility among the functions
For the Reactive Pwer
Control Mode, only one of these four functions
can be valid at one time: QU, PF(P), PF, and Q setting.
To Next Page
Loading...
