69
3. The inverter will enter Standby mode when the output voltage and
power of PV modules do not meet the startup conditions or PV voltage
and input power are lower than the set value. The inverter will check
automatically whether it meets the startup conditions in this mode until
it turns back to normal mode. The inverter will switch from standby
mode to fault mode if a malfunction occurs.
E
-T:0.0kWh
2015-10-22 12：00:00
E-D:0.0kWh
3
6 9 12 15 18 21 24h
15
30
45
60
kWh
Standby Addr:001
PV1:0.0V 0.0A
Figure 4-3 Default Display Interface for Normal Operation
4. If the inverter experiences a Fault it will enter Fault mode and display
the current or most recent faults.
History Record
Running Record
Fault Record
Current Error
Figure 4-4 History Record Interface
To Next Page
Loading...
