Creality CR-10 S5 - My Own Cura 4.1 Settings for the S5 Printer

Appendix – My own Cura 4.1 settings for the S5 printer
Parameters in bold are the ones I would recommend to check for every print.
Values in bold are the ones I changed from the default values.
Parameter name
0.16mm plain
0.25mm plain
Other profiles
Quality
layer height
0,16
0,25
Initial layer height
0,2
0,2
Line width
0,4
Wall line width
0,5
Outer wall line width
0,5
Inner wall line width
0,5
Top/Bottom line width
0,5
Infill line width
0,4
Skirt/Brim line width
0,4
Support line width
0,4
Support interface line width
0,4
Suport roof line width
0,4
Support floor line width
0,4
Initial layer line width
100%
Shell
Wall thickness
1,5
wall line count
3
Outer wall wipe distance
0,4
Top surface skin layers
1
Top/bottom thickness
1,44
1,5
Top thickness
1,44
1,5
top layers
9
6
Bottom thickness
1,44
1,5
bottom layers
9
6
Top/Bottom pattern
zigzag
Bottom pattern initial layer
zigzag
Top/Bottom line directions
[]
Outer wall inset
0
Optimise wall printing order
yes
Outer before inner walls
no
Alternate extra wall
yes
Compensate wall overlaps
yes
compensate outer wall overlap
yes
compensate inner wall overlap
yes
Fill gaps between walls
everywhere