Crown FM600 - Page 106

M (continued)
Mono
operation 2-12, 3-6
Motherboard
circuit description 4-8
Multimeter 3-7
front panel 3-3
N
Nearcast
transmitter use 1-3
Networks
satellite fed 1-6
terrestrial fed 1-5
Noise 1-8, 3-8
measurements 5-9
O
Operating environment 1-8, 2-2
Options 1-3, 1-4,1-5, 1-6
Output
power 1-7, 3-7
display 3-7
Output filter 4-15
P
Part numbering 4-2
Parts
spares 7-2
Performance
checklist 5-7
tests 5-10
Pilot frequency 5-8
Pilot indicator 3-5
Power
AC voltage selection 2-2
input 1-8, 2-2
output 1-3, 1-7, 5-8
display 3-7
output filter 4-15
RF 3-3, 3-7
RF amplifier 4-14
Power supply
high voltage 4-15
low voltage 4-15
Power switch 3-4
Pre-emphasis 1-7, 4-4, 5-2, 5-7
curve 2-14, 4-4
Processing
audio 1-2, 3-5
control 3-6
control setting 3-3
highband 3-5, 4-4
Program failure 2-15, 5-10
Program source 2-12, 3-6
R
Receiver
frequency selection 2-7
option 1-5
specifications 1-9
Reflectometer 4-15
Regulatory approvals 1-8
Remote control 1-2
Remote I/O
connector 2-15
pin out 2-16
Repair
warranty 7-3
RF
amplifier 4-14
bias set 5-6
bandwidth 1-8, 5-8
exciter 1-3
circuit description 4-6
circuit location 1-3, 4-6
input 1-5, 2-12
output 1-2, 1-5, 1-7, 3-3, 3-7
impedance 1-7
output filter 4-15
S
Safety 1-9
Satellator
transmitter use 1-6
SCA 1-5
input connection 2-13
Sensitivity
monaural 1-9
stereo 1-9
Separation
stereo 1-7
stereo generator 5-2
Service
warranty 7-3
Service instructions 7-5
Spare parts 7-2
Specifications
receiver 1-9
transmitter 1-7
I-3 Index