Crown FM600 - Operating Environment Guidelines; Power Connections and Fuse Information

2.1 Operating Environment
You can install the FM transmitter in a standard component rack or on a suitable surface
such as a bench or desk. In any case, the area should be as clean and well ventilated as
possible. Always allow for at least 2 cm of clearance under the unit for ventilation. If you
set the transmitter on a flat surface, install spacers on the bottom cover plate. If you install
the transmitter in a rack, provide adequate clearance above and below. Do not locate the
transmitter directly above a hot piece of equipment.
2.2 Power Connections
The FM600 can operate on any voltage between 120 and 240 volts AC (50 or 60 Hz; single
phase).
2.2.1 AC Line Voltage Setting
Voltage selection is automatic; configuration is not necessary.
2-2 FM600 User’s Manual
Illustration 2–2 AC Input Power Connection
AC Input Power
Connection