Crown FM600 - Receiver Frequency Selection

2-7 Installation
2.4 Receiver Frequency Selection
If you have a transmitter equipped with the receiver option, you will need to set the receiving or
incoming frequency.
1. With the top cover removed, locate the receiver module and the two switches (labeled SW1
and SW2).
Frequency
Switches
J1
J2
Receiver
Module
Illustration 2–11 Receiver Module Switches
2. Use the adjacent chart to set the switches for the desired incoming frequency.
3. For frequencies in the Japan FM band, short pins 7&8 on J1 on the receiver card.
4. For 75us pre-emphasis short pins 3&4 and 5&6 on J2 of the Receiver card.
5. For 50us pre-emphasis short pins 1&2 and 7&8 on J2 of the Receiver card.
6. After setting the frequency, replace the top cover and screws.