4.1 Part Numbering
As this section refers to individual components, you should be familiar with the part numbering
scheme used.
The circuit boards and component placement drawings use designators such as “R1”, “R2”,
and “C1.” These same designators are used throughout the transmitter on several different
circuit boards and component placement drawings. When referencing a particular component
it is necessary to also reference the circuit board that it is associated with.
4-2 FM600 User’s Manual
Resistor R1
Driver Switch Logic Board Audio Processor/Stereo Generator Board
Resistor R1
Illustration 4–1 Resistor R1 On Different Circuit Boards
To Next Page
Loading...
