CTC Union FMC-2000MS - Main Menu

20
3.1.4 Main Menu
****************************************
*** CTC UNION TECHNOLOGIES CO.,LTD ***
*** FMC-2000MS ***
****************************************
[1.000-1.002-0.000-0.000][Standalone]
<1> System
<2> Automatic Laser Shutdown
<3> Ports
<4> Link OAM
<5> SNMP
<6> MAC Table
<7> VLAN
<8> QoS
<9> Diagnostics
<A> Maintenance
<P> Password Change
<S> Save startup-config
[ESC] Logout
<1> System: The system menu is where settings are made for the SNMP MIB2 System Contact, System Name, System Location, plus the
device IP address, the NTP settings for time server and time zone and the working mode of the device (switch or converter). The views are
available for device information (MAC, time, software version) and the system log.
<2> Automatic Laser Shutdown: The ALS is enabled or disabled here for the Fiber port.
<3> Ports: All settings and views for the copper UTP and fiber SFP ports are done here.
<4> Link OAM: The IEEE802.3ah settings and set and viewed under this menu.
<5> SNMP: Enable and set management IP addresses and trap destinations along with community strings for SNMP v1 or v2c.
<6> MAC Table: Setup the MAC aging, static MAC addresses and view the MAC table under this menu.
<7> VLAN: Setup VLAN parameters and members for the Fiber and LAN ports.
<8> QoS: Egress bandwidth control and Broadcast Storm Policing.
<9> Diagnostics: IPv4 and IPv6 PING
<A> Maintenance: Reset, default, configuration up/download, software upgrade.
<P> Password: Set the console/web login password.
<S> Save: Copies the running-config to the startup-config