28
<4> Remote Device (FMC-2000MS): This menu item allows entering configuration of the remote OAM fiber connected converter. If the
remote converter is not seen, make sure that OAM is enabled on both converters and make sure the local converter is in 'active' mode. The
factory default has the converters in 'passive' mode. OAM cannot link unless at least one device is in 'active' mode.
{ Link-OAM > Remote Device > FMC-2000MS }
Ver [1.000-1.000-0.000-0.000]
MAC [00:02:AB:A0:B8:0E ]
<1> System IP <5> OAM
<2> Automatic Laser Shutdown <6> VLAN
<3> Port Configuration <7> QoS
<4> SFP
[ESC] Go to previous menu. Please select an item.
All settings for the remote are performed exactly the same as those of the local converter described here.
3.1.9 SNMP
The SNMP settings are divided into two groups, one for Manager Configuration and one for Trap Configuration.
{ SNMP }
<1> Community [192.168.0.114 ][private ][read-write]
<2> Community [192.168.0.114 ][public ][read-only ]
<3> Community [ ][ ][read-only ]
<4> Community [ ][ ][read-only ]
<5> Trap Community [192.168.0.114 ][public ]
<6> Trap Community [ ][ ]
<7> Trap Community [ ][ ]
<8> Trap Community [ ][ ]
Up to 4 management IPs can be configured, their community string defined, and their access defined as read-only or read-write. A read-only
manager is only able to perform 'get' commands. All 'set' commands are reserved for a manager given read-write control.
Traps are unsolicited messages issued by this SNMP agent, that typically indicate some alarm condition has occurred. Up to 4 Trap receivers
(managers that receive the traps) are configured here and include the manager's IP address and an authentication community string.
To Next Page
Loading...
