9
1.3 Product Features
▪ Auto-Cross over for MDI/MDIX at UTP port
▪ Auto-Negotiation or Forced Manual mode for UTP port
▪ Supports Dual Rate (100/1000) SFP for selectable Fast or Gigabit speed on fiber
▪ Supports 802.3x flow control Enable or Disable
▪ Supports Jumbo Frames up to 16K bytes
▪ Supports 16 Tag VLAN Groups
▪ Supports 802.1Q tagging and 802.1ad double VLAN tag (Q-in-Q)
▪ Egress Bandwidth control with 64Kbps granularity
▪ Supports 802.3ah-OAM loop back and dying gasp (remote power failure detection)
▪ Supports firmware upgrade via Xmodem, TFTP and Web
▪ Supports Digital Optical Diagnostics (DOM) for supported SFP
▪ Provides product information for SNMP management
▪ Includes RMON counters (stand-alone only)
▪ Supports password setting for authentication
▪ Supports Link Fault Pass Through (LFPT) Function
▪ Supports Auto Laser Shutdown (ALS) Function
▪ Supports DHCP client for automatic TCP/IP configuration
▪ Supports NTP v3/4 client with manual Timezone setting
FMC-2000MS SFP socket supports a wide range of standard SFP modules to address any network situation.
Single-mode, Multi-mode, Multi-rate, Dual Rate (100M or 1G), Single fiber bi-directional, Coarse and Dense Wave Division Multiplexing
(CWDM and DWDM) and Copper media SFPs
WARNING: Fiber optic equipment may emit laser or infrared light that can injure your eyes. Never look into an optical fiber or connector port.
Always assume that fiber optic cables are connected to an active laser light source.
To Next Page
Loading...
