CTC Union FMC-2000MS - Appendix; MIB Description

61
Appendix
MIB Description
Label
OID
Access
Description
ctcAutoProvisioningStatusGlobalsDHCPv4Bound
.1.3.6.1.4.1.4756.189.20.145.1.3.1.3
ReadOnly
Indicates DHCPv4 IP address is
bound or not.
ctcAutoProvisioningStatusGlobalsConfigurationUpToDate
.1.3.6.1.4.1.4756.189.20.145.1.3.1.2
ReadOnly
Indicates the configuration is up to
date or not.
ctcAutoProvisioningStatusGlobalsSoftwareUpToDate
.1.3.6.1.4.1.4756.189.20.145.1.3.1.1
ReadOnly
Indicates the software is up to
date or not.
ctcAutoProvisioningConfigGlobalsVendorClassIdentifier
.1.3.6.1.4.1.4756.189.20.145.1.2.1.2
ReadWrite
Configure the DHCP option 60
vendor class identifier. The
allowed string length is 0 to 63 and
the allowed content is the ASCII
characters from 32 to 126. This
value is not necessary in the DHCP
server. However once this vendor
class identifier is specified the
device must have the same vendor
class identifier so as to accepte
Auto-provisioning values.
ctcAutoProvisioningConfigGlobalsMode
.1.3.6.1.4.1.4756.189.20.145.1.2.1.1
ReadWrite
Indicates the auto provision mode
operation. Possible modes are:
Enabled: Enable auto provision
mode operation. Disabled: Disable
auto provision mode operation.
ctcIpStatusInterfacesAddress
.1.3.6.1.4.1.4756.189.20.102.1.3.2.1.1.4
ReadWrite
The current address of the
interface (of the given type).
ctcIpConfigInterfacesIpv6Ipv6Address
.1.3.6.1.4.1.4756.189.20.102.1.2.2.4.4
ReadWrite
Static configured IPv6 address.
ctcIpConfigInterfacesIpv6EnableDhcpClient
.1.3.6.1.4.1.4756.189.20.102.1.2.2.4.3
ReadWrite
Enable IPv6 DHCP client.
ctcIpConfigInterfacesIpv4Gateway
.1.3.6.1.4.1.4756.189.20.102.1.2.2.3.6
ReadWrite
Gateway.
ctcIpConfigInterfacesIpv4PrefixSize
.1.3.6.1.4.1.4756.189.20.102.1.2.2.3.5
ReadWrite
Prefix size of the network.
ctcIpConfigInterfacesIpv4Ipv4Address
.1.3.6.1.4.1.4756.189.20.102.1.2.2.3.4
ReadWrite
IPv4 address.
ctcIpConfigInterfacesIpv4EnableDhcpClient
.1.3.6.1.4.1.4756.189.20.102.1.2.2.3.3
ReadWrite
Enable IPv4 DHCP client. Note: the
DHCP client can only be enabled if
there is no conflict in the values of:
ipv4Address prefixSize and
dhcpClientFallbackTimeout.