24
<2> Fiber Flow Control: Enables or disables the 802.3x Ethernet flow control for the port.
----------------------------------------------------------
<0> Disable <1> Enable <ESC> Exit
<3> LAN Speed: Sets up the LAN port speed and duplex or sets in auto-negotiation mode. (hdx= half duplex, fdx= full duplex)
----------------------------------------------------------------------
<0> Disable <1> 10hdx <2> 10fdx <3> 100hdx
<4> 100fdx <5> 1Gfdx <6> Auto <ESC> Exit
<4> LAN Flow Control: Enables or disables the 802.3x Ethernet flow control for the port.
----------------------------------------------------------
<0> Disable <1> Enable <ESC> Exit
<5> LFTP: Link Fault Pass-Through causes loss of link on one side of a media converter to be passed through to the other side, so that
upstream equipment can see fault conditions that would otherwise be hidden by the media converters. LFTP, when enabled, will pass the link
fault both ways, i.e., from LAN to FIBER and from FIBER to LAN.
----------------------------------------------------------
<0> Disable <1> Enable <ESC> Exit
<6> Jumbo Frame: This device can enable support for jumbo frames (>1518) to support up to 16Kbytes Ethernet frames.
----------------------------------------------------------
<0> Disable <1> Enable <ESC> Exit
<7> SFP Status: Displays the DDOM of the installed SFP module.
Vendor Name [OEM ]
Vendor PN [GLC-BX-20U ]
Vendor SN [1807100006 ]
Fiber Type [Single mode]
Wave Length [1550 nm]
Wave Length(2) [0000 nm]
Link Length [20 Km]
TX Power [-5.52 dBm]
RX Power [-3.60 dBm]
Rx Sensitivity [0 dBm]
Tx Bias [24.7060 mA]
Supply Voltage [3.4240 V]
Temperature [54.00 degree C]
To Next Page
Loading...
