CHAPTER 4 8454
4-26
D569-W02 May-2003
Hydraulic Pipes
1. Remove the brake rod (4) and delivery pipe (3).
2. Remove the delivery pipe (2).
3. Slide the rubber hose (1).
(When reassembling)
• Reinstall the pipe clamps securely.
Separating the Engine From Clutch Housing
1. Place the jack under the clutch housing case.
2. Hoist the engine by the nylon lift strap at the tank support.
3. Remove the engine mounting screws, and then pull
the engine to the front.
(When reassembling)
• Apply grease to the splines.
• Apply liquid gasket (There Bond 1208D or
equivalent) to joint face of the engine and clutch
housing.
Tightening
torque
Join bolt for
delivery pipe (3)
and front
hydraulic block
Joint bolt for
delivery
pipe (2) and
regulator valve
49.0 ~ 58.8 N·m
5.0 ~ 6.0 kgf·m
36.2 ~ 43.4 lbf·ft
34.3 ~ 39.2 N·m
3.5 ~ 4.0 kgf·m
25.3 ~ 28.9 lbf·ft
Tightening
torque
Engine and clutch
housing
mounting screws,
nuts
Engine and clutch
housing
mounting stud
bolts
77.5 ~ 90.2 N·m
7.9 ~ 9.2 kgf·m
57.1 ~ 66.5 lbf·ft
39.2 ~ 49.0 N·m
4.0 ~ 5.0 kgf·m
28.9 ~ 36.2 lbf·ft
569W438A
569W439A
D. SEPARATING CLUTCH HOUSING
Propeller Shaft
1. Slide the propeller shaft cover (4), (5) after remov-
ing the bolt (9).
2. Tap out the spring pin (10) and then slide the cou-
pling (2) to the front.
(When reassembling)
• Apply grease to the splines of the propeller shaft.
(1) Propeller Shaft (6) O-Ring
(2) Coupling (7) O-Ring
(3) Cir-Clip (8) O-Ring
(4) Propeller Shaft Cover (9) Bolt
(5) Propeller Shaft Cover (10) Spring Pin
569W437A
(1) Rubber hose (3) Delivery pipe
(2) Delivery pipe (4) Brake rod
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General
