Custom Audio Electronics Q3X - Page 78

 Platen roller
1
2
1
2
Disconnect the power supply cable and
open the device cover (see paragraph 5.2).
Clean the printinghead by using
a non-abrasive cloth moistened with isopropyl.
ATTENTION:
Do not use solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Clean the platen roller by using
a non-abrasive cloth moistened with isopropyl.
Disconnect the power supply cable and
open the device cover (see paragraph 5.2).
ATTENTION:
Do not use solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
ISOPROPYL ALCOHOL ISOPROPYL ALCOHOL
Disconnect the power supply cable and
open the device cover (see paragraph 5.2).
Disconnect the power supply cable and
open the device cover (see paragraph 5.2).
78