Custom Audio Electronics Q3X - Page 79

Case Cutter
1
2
1
2
Disconnect the power supply cable.
To clean the device,
use compressed air or a soft cloth.
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Alcohol, solvent
Disconnect the power supply cable and
open the device cover (see paragraph 5.2).
Clean the cutter compartment from the inside
using compressed air.
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Alcohol, solvent
Disconnect the power supply cable and
open the device cover (see paragraph 5.2).
79