D-Link DES-3010G - Initializing Ports for Port Based 802.1 X

DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
Initializing Ports for Port Based 802.1x
Existing 802.1x port and MAC settings are displayed and can be configured using the window below.
Click Security > 802.1X > Initialize Ports to view the following window:
Figure 10- 18. Initialize Port window
This window allows you to initialize a port or group of ports. The Initialize Port Table in the bottom half of the window displays
the current status of the port(s).
This window displays the following information:
Parameter Description
From and To
Select ports to be initialized.
Port
A read only field indicating a port on the Switch.
MAC Address
The MAC address of the Switch connected to the corresponding port, if any.
Auth PAE State
The Authenticator PAE State will display one of the following: Initialize, Disconnected,
Connecting, Authenticating, Authenticated, Aborting, Held, ForceAuth or ForceUnauth.
Backend State
The Backend Authentication State will display one of the following: Request, Response,
Success, Fail, Timeout, Idle or Initialize.
Open Dir
The Operational Controlled Directions are both and in.
Port Status
The status of the controlled port can be Authorized or Unauthorized.
129