DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
SMTP Server Settings
The following window is used to configure the fields to set up the SMTP server for the switch, along with setting e-mail
addresses to which switch log files can be sent when a problem arises on the Switch. To open the following window, open the
Administration folder, then the SMTP Service folder and then click the SMTP Server Settings link.
Figure 6- 57. SMTP Service Settings and Mail Receiver Address Table window
The following parameters can be set:
Parameter Description
SMTP State
Use the pull-down menu to enable or disable the SMTP service on this device.
SMTP Server Address
Enter the IP address of the SMTP server on a remote device. This will be the device that
sends out the mail for you.
SMTP Server Port
Enter the virtual port number that the Switch will connect with on the SMTP server. The
common port number for SMTP is 25, yet a value between 1 and 65535 can be chosen.
Self Mail Address
Enter the e-mail address from which mail messages will be sent. This address will be the
“from” address on the e-mail message sent to a recipient. Only one self mail address can
be configured for this Switch. This string can be no more that 64 alphanumeric characters.
Mail Receiver Address
Enter a list of e-mail addresses so recipients can receive e-mail messages regarding
Switch functions. Up to 8 e-mail addresses can be added per Switch. Do delete these
addresses from the Switch, click it’s corresponding under the Delete heading in the Mail
Receiver Address Table.
Click Apply to implement changes made.
71
To Next Page
Loading...
