3.25. IGMPRule
Description
An IGMP rule specifies how to handle inbound IGMP reports and outbound IGMP queries.
Properties
Index
The index of the object, starting at 1. (Identifier)
Name
Specifies a symbolic name for the rule. (Optional)
Type
The type of IGMP messages the rule applies to.
(Default: Report)
Action
Drop, Snoop, Proxy or PIM. (Default: Drop)
SourceInterface
Specifies the name of the receiving interface to be
compared to the received packet.
SourceNetwork
Specifies the sender span of IP addresses to be com-
pared to the received packet.
DestinationInterface
Specifies the the destination interface to be com-
pared to the received packet. (Default: core)
MulticastGroup
Specifies the multicast group to be compared to the
received packet.
MulticastSource
Specifies the multicast source to be compared to the
received packet.
RelayInterface
Specifies the interface via which to relay IGMP mes-
sages.
TranslateMGroup
Translate the multicast group for packets matching
this rule. (Default: No)
GrpAllToOne
Rewrite all multicast groups to a single IP. (Default:
No)
NewGrpIP
Translate the multicast group to this address.
TranslateMSource
Translate the multicast source for packets matching
this rule. (Default: No)
SrcAllToOne
Rewrite all multicast sources to a single IP. (Default:
No)
NewSrcIP
Translate the multicast source to this address.
Filter
Pass IGMP data not matching this rule to the next
rule. (Default: Yes)
LogEnabled
Enable logging. (Default: Yes)
LogSeverity
Specifies with what severity log events will be sent
to the specified log receivers. (Default: Default)
Comments
Text describing the current object. (Optional)
3.25. IGMPRule Chapter 3. Configuration Reference
119
To Next Page
Loading...
