3.52. Settings
This is a category that groups the following object types.
3.52.1. ARPNDSettings
Description
Advanced ARP/Neighbor Discovery-table settings.
Properties
ARPMatchEnetSender
The Ethernet Sender address matching the hardware
address in the ARP data. (Default: DropLog)
ARPQueryNoSenderIP
If the IP source address of an ARP query (NOT re-
sponse!) is "0.0.0.0". (Default: DropLog)
ARPSenderIP
The IP Source address in ARP packets. (Default:
Validate)
UnsolicitedARPReplies
Unsolicited ARP replies. (Default: DropLog)
ARPRequests
Specifies whether or not the ARP requests should
automatically be added to the ARP table. (Default:
Drop)
ARPChanges
ARP packets that would cause an entry to be
changed. (Default: AcceptLog)
StaticARPChanges
ARP packets that would cause static entries to be
changed. (Default: DropLog)
ARPExpire
Lifetime of an ARP entry in seconds. (Default: 900)
ARPExpireUnknown
Lifetime of an "unknown" ARP entry in seconds.
(Default: 3)
ARPMulticast
ARP packets claiming to be multicast addresses;
may need to be enabled for some load balancers/
redundancy solutions. (Default: DropLog)
ARPBroadcast
ARP packets claiming to be broadcast addresses;
should never need to be enabled. (Default: DropLog)
ARPCacheSize
Number of ARP entries in cache, total. (Default:
4096)
ARPHashSize
Number of ARP hash buckets per physical interface.
(Default: 512)
ARPHashSizeVLAN
Number of ARP hash buckets per VLAN interface.
(Default: 64)
LogResolveFailure
Specifies whether or not to log failed ARP Resolves.
(Default: Yes)
NDRateLimit
Rate limit originated ND packets. (Default: 1000)
3.52. Settings Chapter 3. Configuration Reference
171
To Next Page
Loading...
