D-Link DFL-260E

context, just type show. Show a table of all objects of a type by specifying a type or a category. Use
the -errors or -changes flags to show what objects have been changed or have errors in the
configuration.
When showing a table of all objects of a certain type, the status of each object since the last time the
configuration was committed is indicated by a flag. The flags used are:
-
The object is deleted.
o
The object is disabled.
!
The object has errors.
+
The object is newly created.
*
The object is modified.
Additional flags:
D
The object has dynamic properties which are updated by the system.
When listing categories and object types, categories are indicated by [] and types where objects may
be contexts by /.
Example 2.6. Show objects
Show the properties of an individual object:
gw-world:/> show Address IP4Address example_ip
gw-world:/main> show Route 1
gw-world:/> show Client DynDnsClientDyndnsOrg
Show a table of all objects of a type and a selection of their
properties as well as their status:
gw-world:/> show Address IP4Address
gw-world:/> show IP4Address
Show a table of all objects for each type in a category:
gw-world:/> show Address
Show objects with changes and errors:
gw-world:/> show -changes
gw-world:/> show -errors
Show what objects use (refer to) a certain object:
gw-world:/> show Address IP4Address example_ip -references
Usage
show
Show the types and categories available in the current context.
show [<Category>] [<Type> [<Identifier>]] [-disabled] [-references]
Show an object or list a type or category.
show -errors [-verbose]
Show all errors.
show -changes
2.1.11. show Chapter 2. Command Reference
27