D-Link DFL-260E

can be passed onward. (Default: 1456)
AutoInterfaceNetworkRoute
Automatically add a route for this interface using the
given remote network. (Default: Yes)
MPPEAllowStateful
Allow usage of Stateful MPPE (less secure, use only
for compatibility). (Default: No)
Comments
Text describing the current object. (Optional)
3.28.7. L2TPServer
Description
A PPTP/L2TP server interface terminates PPP (Point to Point Protocol) tunnels set up over existing
IP networks.
Properties
Name
Specifies a symbolic name for the interface.
(Identifier)
IP
The IP address of the PPTP/L2TP server interface.
TunnelProtocol
Specifies if PPTP or L2TP should be used for this
tunnel. (Default: PPTP)
Interface
The interface that the PPTP/L2TP Server should be
listening on.
ServerIP
Specifies the IP that the PPTP/L2TP server should
listen on, this can be an IP of a interface, or for ex-
ample an ARP published IP.
UseUserAuth
Enable the use of user authentication rules on this
server. (Default: Yes)
MPPENone
Allow no authentication for this tunnel. (Default:
Yes)
MPPERC440
Use an RC4 40 bit MPPE session key with MS-
CHAP or MS-CHAP v2 authentication protocol.
(Default: Yes)
MPPERC456
Use an RC4 56 bit MPPE session key with MS-
CHAP or MS-CHAP v2 authentication protocol.
(Default: Yes)
MPPERC4128
Use an RC4 128 bit MPPE session key with MS-
CHAP or MS-CHAP v2 authentication protocol.
(Default: Yes)
IPPool
A range, group or network that the PPTP/L2TP serv-
er will use as IP address pool to give out IP ad-
dresses to the clients from.
DNS1
IP of the primary DNS server. (Optional)
DNS2
IP of the secondary DNS server. (Optional)
3.28.7. L2TPServer Chapter 3. Configuration Reference
129