Comments
Text describing the current object. (Optional)
Note
If no Index is specified when creating an instance of this type, the object will be
placed last in the list and the Index will be equal to the length of the list.
3.49.2. Route
Description
A route defines what interface and gateway to use in order to reach a specified network.
Properties
Name
Specifies a symbolic name for the object. (Optional)
Interface
Specifies which interface packets destined for this
route shall be sent through.
Gateway
Specifies the IP address of the next router hop used
to reach the destination network. If the network is
directly connected to the security gateway interface,
no gateway address is specified. (Optional)
LocalIP
The IP address specified here will be automatically
published on the corresponding interface. This ad-
dress will also be used as the sender address in ARP
queries. If no address is specified, the security gate-
way's interface IP address will be used. (Optional)
Network
Specifies the network address for this route.
RouteMonitor
Specifies if this route should be monitored for route
changes for route failover purposes. (Default: No)
MonitorLinkStatus
Mark the route as down if the interface link status
changes to down. (Default: No)
MonitorGateway
Mark the route as down if the next hop does not an-
swer on ARP lookups during a specified time.
(Default: No)
MonitorGatewayManualARP
Enable a manually specified ARP lookup interval.
(Default: No)
MonitorGatewayARPInterval
Specifies the ARP lookup interval in milliseconds.
(Default: 1000)
EnableHostMonitoring
Enables the Host Monitoring functionality. (Default:
No)
Reachability
Specifies the number of hosts that are required to be
reachable to consider the route to be active. (Default:
ALL)
GracePeriod
Specifies the time to wait after a reconfiguration un-
til the monitoring begins. (Default: 5)
3.49.2. Route Chapter 3. Configuration Reference
163
To Next Page
Loading...
