D-Link DFL-260E

PPPAuthNoAuth
Allow no authentication for this tunnel. (Default:
No)
PPPAuthPAP
Use PAP authentication protocol for this tunnel.
User name and password are sent in plaintext.
(Default: Yes)
PPPAuthCHAP
Use CHAP authentication protocol for this tunnel.
(Default: Yes)
PPPAuthMSCHAP
Use MS-CHAP authentication protocol for this tun-
nel. (Default: Yes)
PPPAuthMSCHAPv2
Use MS-CHAP v2 authentication protocol for this
tunnel. (Default: Yes)
DialOnDemand
Enable Dial-on-demand which means that the
PPPoE tunnel will not be setup until traffic is sent on
the interface. (Default: No)
ActivitySensing
Specifies if the dial-on-demand should trigger on in-
bound or outbound traffic or both. (Default: BiDirec-
tional)
IdleTimeout
Idle timeout in seconds for dial-on-demand.
(Default: 3600)
Metric
Specifies the metric for the auto-created route.
(Default: 90)
AutoInterfaceNetworkRoute
Automatically add a route for this interface using the
given remote network. (Default: Yes)
Schedule
The schedule defines when the PPPoE tunnel should
be active. (Optional)
ForceUnnumbered
Force the PPPoE tunnel to be unnumbered. (Default:
No)
SpecifyManually
Make it possible to manually specify IP Address ob-
ject. (Default: No)
MTU
Specifies the size (in bytes) of the largest packet that
can be passed onward. (Default: 1492)
Comments
Text describing the current object. (Optional)
3.28.9. SSLVPNInterface
Description
An SSL VPN interface, together with the bundled client, creates an easy to use tunnel solution for
roaming users.
Properties
Name
Specifies a symbolic name for the interface.
(Identifier)
3.28.9. SSLVPNInterface Chapter 3. Configuration Reference
131