-ipdest=<IP4 Address>
Destination IP address filter.
-ipsrc=<IP4 Address>
Source IP address filter.
-ipversion=<1...15>
IP version filter.
-out
Realtime packet brief dumped to console.
-out-nocap
Unbuffered (not stored in memory) realtime packet
brief dumped to console.
-port=<0...65535>
TCP/UDP port filter.
-promisc
Set iface in promiscuous mode.
-proto=<0...255>
IP protocol filter.
-show
Show a captured packets brief.
-size=<value>
Size (kb) of buffer to store captured packets in
memory (default 512kb).
-snaplen=<value>
Maximum length of each packet to capture.
-srcport=<0...65535>
Source TCP/UDP port filter.
-start
Start capture.
-status
Show capture status.
-stop
Stop capture.
-tcp
TCP filter.
-udp
UDP filter.
-wipe
Remove all captured packets from memory.
-write
Write the captured packets to disk.
<interface(s)>
Name of interface(s).
Note
Requires Administrator privilege.
2.2.40. pipes
Show pipes information.
Description
Show list of configured pipes / pipe details / pipe users.
Note: The "pipes" command is not executed right away; it is queued until the end of the second,
when pipe values are calculated.
Usage
2.2.40. pipes Chapter 2. Command Reference
53
To Next Page
Loading...
