D-Link DGS-1210-08P - Hardware Installation; Safety Cautions

1 Product Introduction D-Link Smart Managed Switch User Manual
4
(installations extérieures), notamment des environnements de
campus, et l’ITE doit être connecté uniquement à des réseaux PoE
sans acheminement vers une installation extérieure." ou
équivalent.
CAUTION: The equipment power supply cord shall be connected
to a socket-outlet with earthing connection.
ATTENTION:
Le cordon d'alimentation de l'équipement doit être
branché sur une prise de courant dotée d'une connexion à la terre.
NOTE: The port 1 ~ port 8 are PoE ports. When user press the
Mode button to PoE mode, only port 1 ~ port 8 will light up.
Rear Panel
Figure 1.2 – DGS-1210-08P Rear Panel
Power: Connect the supplied DC external power 54V/1.574A cable to this port.
DGS-1210-16
16-Port 10/100/1000Mbps plus 4 Combo GE/SFP Slot Smart Managed Switch.
Front Panel
Figure 1.3 – DGS-1210-16 Front Panel
The front panel of the DGS-1210-16 switch consists out of the following:
• Power LED
: The Power LED lights up when the Switch is connected to a power source.
• Port Link/Act/Speed LED (1-16): The Link/Act/Speed LED flashes, which indicates a network link
through the corresponding port. Blinking indicates that the Switch is either sending or receiving data to
the port. When a port has an amber light, this indicates that the port is running on 10M or 100M. When
it has a green light it is running on 1000M.
• Port Link/Act/Speed LED (17F, 18F, 19F, 20F, 17T, 18T, 19T, 20T): The Link/Act/Speed LED flashes,
which indicates a network link through the corresponding port. Blinking indicates that the Switch is
either sending or receiving data to the port. When the port LED glows in amber, it indicates the port is
running on 100M. When the port LED glows in green, it is running on 1000Mbps.
• Reset: Press the Reset button for 1~5 seconds to reboot the device. Press the Reset button for 6~10
seconds to reset the Switch back to the default settings and led will be solid light with amber for 2
seconds. Or press the Reset button over 11 seconds to enter the loader mode after device reboot and