D-Link DGS-1210-08P - Firmware Backup and Upgrade; Nuclias Connect Setting

4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
2
2
7
7
Firmware Backup and Upgrade
Allow for the firmware to be saved, or for an existing firmware file to be uploaded to the Switch. Two methods
can be selected: HTTP or TFTP.
Figure 4.15 – Tool Menu > Firmware Backup and Upload
HTTP: Backup or upgrade the firmware to or from your local PC drive.
Click Backup to save the firmware to your disk.
Click Choose File to browse your inventories for a saved firmware file.
Click Upgrade after selecting the firmware file you want to restore.
TFTP: TFTP (Trivial File Transfer Protocol) refers to the file transfer protocol that provides user a quick and
convenient method for file transfer.
Selectable TFTP server IP address mode from IPv4 address, IPv6 address or Domain Name.
Click Backup to save the firmware to the TFTP server.
Click Upgrade after selecting the firmware file you want to restore.
CAUTION: Do not disconnect the PC or remove
the power cord from device until the upgrade
completes. The Switch may crash if the
Firmware upgrade is incomplete.
Nuclias Connect Setting
This page contains the Nuclias Connect Settings of the Switch.
Figure 4.16 – Tool Menu > Nuclias Connect Setting
Nuclias Connect, D-Link’s centralized management solution for Small-to-Medium-Sized Business (SMB)
networks. Nuclias Connect makes it easier to analyze, automate, configure, optimize, scale, and secure your
network — delivering the convenience of an Enterprise-wide management solution, at an SMB price.
Nuclias Connect State: Enable/Disable the Nuclias Connect State.
Nuclias Connect Status: Presents the Nuclias Connection Status which includes “Connection Status”,
“Server IP/Port” and “Group ID”.