D-Link DGS-1210-08P - Command Line Interface (CLI); Connecting via TELNET; Logging On to CLI; Basic CLI Commands

5 Surveillance Mode Configuration D-Link Smart Managed Switch User Manual
134
Mask Specifies the netmask for the surveillance VLAN management IP.
Gateway Specifies the gateway for the surveillance VLAN.
Click the Apply button to implement changes made.
The fields that can be configured for the SNMP Host Settings are described below:
Parameter Description
Community Name/SNMPv3
User Name
Specifies
the community name or SNMPv3 user name to be
configured.
Host Ipv4 Address
Specifies the IPv4 address of the SNP Network Management Server
(NMS) which will receive SNMP Traps from this device.
Click the Apply button to implement changes made.
The fields that can be configured for the Log Server are described below:
Parameter Description
Host IPv4 Address
Specifies the
IPv4 address of the Syslog NMS which will receive
Syslog messages from this device.
Host Ipv4 Address
Specifies
the IPv6 address of the Syslog NMS which will receive
Syslog messages from this device.
Click the Apply button to implement changes made.
The fields that can be configured for the Password Settings are described below:
Parameter Description
Old Password
Enter the old password that is used to restrict access to the device via
the Web UI. Password length is a maximum of 20 characters.
New Password
Configure a new password that will be used to restrict access to the
device via the Web UI. Password length is a maximum of 20
characters.
Confirm Password
Confirm the password that will be used to restrict access to the device
via the Web UI. Password length is a maximum of 20 characters.
Click the Apply button to implement changes made.
The fields that can be configured for the Uplink Port Settings are described below:
Parameter Description
From Port
Specifies the start port in the range for Uplink Ports. These are used
for connecting the surveillance VLAN with other switches.
To Port
Specifies the end port in the range for Uplink Ports. These are used for
connecting the surveillance VLAN with other switches.
Click the Add button to implement changes made.
Click the Delete button to delete any entries in the list of uplink ports.
Surveillance Log
The Surveillance Log page consists of a list of Syslog messages that have been generated by the switch.
Depending on whether a Syslog server has been defined in the Surveillance Settings section, these may be
local to the switch or copied to an external logging server. The messages are ordered in date order with the
latest message at the top of the list. Please consult an external source for more information on syslog
logging levels.