1 Product Introduction D-Link Smart Managed Switch User Manual
6
NOTE: On the DGS-1210-24, the MiniGBIC ports are shared with
normal RJ-45 ports 25T, 26T, 27T and 28T. When the MiniGBIC
port is used, the RJ-45 port cannot be used.
CAUTION: The MiniGBIC ports should use UL
Transceiver product, Rated Laser Class I. 3.3Vdc.
ATTENTION: C
e produit est destiné à être utilisé avec un
transceiveur optique homologué UL,tension DC3.3V, classe laser
I.
Rear Panel
Figure 1.6 – DGS-1210-24 Rear Panel
Power: Connect the supplied AC power cable to this port.
DGS-1210-24P
24-Port 10/100/1000Mbps plus 4 Combo GE/SFP Smart Managed PoE Switch.
Front Panel
Figure 1.7 – DGS-1210-24P Front Panel
The front panel of the DGS-1210-24P switch consists out of the following:
• Power LED
: The Power LED lights up when the Switch is connected to a power source.
• Fan Error: The FAN LED shows the status of the fans, light off indicates all fans work fine and the red
light indicates that one or multiple fans are working abnormally.
• PoE Max: The PoE Max LED lights up with solid amber when the Switch reaches the maximum power
budget defined by the administrator via PoE System Settings page of Web GUI or the default power
budget of 193 Watts.
• LED Mode: To select the mode of port LED, the Link/Act and PoE LED under the mode button will
solid green to indicate which mode is selected.
• Port Link/Act/Speed LED (1-24): The Link/Act/Speed LED flashes, which indicates a network link
through the corresponding port. Blinking indicates that the Switch is either sending or receiving data to
the port. When a port has an amber light, this indicates that the port is running on 10M or 100M. When
it has a green light it is running on 1000M.
• Port Link/Act/Speed LED (25F, 26F, 27F, 28F, 25T, 26T, 27T, 28T): The Link/Act/Speed LED flashes,
which indicates a network link through the corresponding port. Blinking indicates that the Switch is
either sending or receiving data to the port. When the port LED glows in amber, it indicates the port is
running on 100M. When the port LED glows in green, it is running on 1000Mbps.
• Reset: Press the Reset button for 1~5 seconds to reboot the device. Press the Reset button for 6~10
seconds to reset the Switch back to the default settings and led will be solid light with amber for 2
seconds. Or press the Reset button over 11 seconds to enter the loader mode after device reboot and
To Next Page
Loading...
