D-Link DGS-1210-08P - Front Panel; Rear Panel; LED Indicators

1 Product Introduction D-Link Smart Managed Switch User Manual
8
Front Panel
Figure 1.9 – DGS-1210-48 Front Panel
The front panel of the DGS-1210-48 switch consists out of the following:
• Power LED
: The Power LED lights up when the Switch is connected to a power source.
• Port Link/Act/Speed LED (1-48): The Link/Act/Speed LED flashes, which indicates a network link
through the corresponding port. Blinking indicates that the Switch is either sending or receiving data to
the port. When a port has an amber light, this indicates that the port is running on 10M or 100M. When
it has a green light it is running on 1000M.
• Port Link/Act/Speed LED (49F, 50F, 51F, 52F, 49T, 50T, 51T, 52T): The Link/Act/Speed LED flashes,
which indicates a network link through the corresponding port. Blinking indicates that the Switch is
either sending or receiving data to the port. When the port LED glows in amber, it indicates the port is
running on 100M. When the port LED glows in green, it is running on 1000Mbps.
• Reset: Press the Reset button for 1~5 seconds to reboot the device. Press the Reset button for 6~10
seconds to reset the Switch back to the default settings and led will be solid light with amber for 2
seconds. Or press the Reset button over 11 seconds to enter the loader mode after device reboot and
the led will be solid light with green for 2 seconds. If the device cannot reboot the Switch, the device will
enter the loader mode automatically.
NOTE: On the DGS-1210-48, the MiniGBIC ports are shared with
normal RJ-45 ports 49T, 50T, 51T and 52T. When the MiniGBIC
port is used, the RJ-45 port cannot be used.
CAUTION: The MiniGBIC ports should use UL
listed Optical
Transceiver product, Rated Laser Class I. 3.3Vdc.
ATTENTION:
Ce produit est destiné à être utilisé avec un
transceiveur optique homologué UL,tension DC3.3V, classe laser
I.
Rear Panel
Figure 1.10 – DGS-1210-48 Rear Panel
Power: Connect the supplied AC power cable to this port.
LED Indicators
The Switch supports LED indicators for Power, Fan, and Link/Act for each port. The following shows the LED
indicators for the DGS-1210 series Smart Managed Switch along with an explanation of each indicator.