5 Surveillance Mode Configuration D-Link Smart Managed Switch User Manual
138
Figure 5.22 – Surveillance Mode > Tools Menu > Firmware Backup & Upgrade
Click Backup to save the firmware to your disk.
Click Choose File to browse your inventories for a saved firmware file.
Click Upgrade after selecting the firmware file you want to restore.
The fields that can be configured with TFTP section are described below:
Parameter Description
TFTP Server IP Address Specifies the IPv4 or IPv6 Address to be used.
TFTP File Name
Choose the file name for the firmware file you want to save to / restore
from.
Click Backup to save the firmware to the TFTP server.
Click Upgrade after selecting the firmware file you want to restore.
Note: Do not disconnect the PC or remove the power cord
from device until the upgrade completes. The Switch may
crash if the firmware upgrade is incomplete.
Firmware Information
The Firmware Information page displays the information of firmware. The user can specify configuration ID
and image file to boot up when power on the Switch next time.
Figure 5.23 – Surveillance Mode > Tools Menu > Firmware Information
Flash Information
The Flash Information displays the flash detail information of the Switch.
To Next Page
Loading...
