D-Link DGS-1210-08P - Configuration Backup & Restore; Firmware Backup and Upgrade

5 Surveillance Mode Configuration D-Link Smart Managed Switch User Manual
1
1
3
3
7
7
Configuration Backup & Restore
Allow the current configuration settings to be saved to a file (not including the password), and if necessary,
you can restore configuration settings from this file. Two methods can be selected: HTTP or TFTP.
Figure 5.21 – Surveillance Mode > Tools Menu > Configuration Backup & Restore
The fields that can be configured with HTTP section are described below:
Parameter Description
Backup/Restore Config ID
number:
Select config_id 1 or config_id 2 to backup or restore the configuration
file.
Click Backup to save the current settings to your disk.
Click Choose File to browse your inventories for a saved backup settings file.
Click Restore after selecting the backup settings file you want to restore.
The fields that can be configured with TFTP section are described below:
Parameter Description
Backup/Restore
Config ID
number:
Select config_id 1 or config_id 2 to backup or restore the configuration
file.
TFTP Server IP Address Specifies the IPv4 or IPv6 Address to be used.
TFTP File Name
Choose the file name for the configuration file you want to save to /
restore from.
Click Backup to save the current settings to the TFTP server.
Click Restore after selecting the backup settings file you want to restore.
Note: Switch will reboot after restore, and
all current configurations will be lost.
Firmware Backup and Upgrade
Allow for the firmware to be saved, or for an existing firmware file to be uploaded to the Switch. Two methods
can be selected: HTTP or TFTP.