4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
4
4
5
5
Figure 4.43 – System > D-Link Discover Protocol Settings
D-Link Discover Protocol State: Enable or disable the Discover Protocol state. The default value is
enabled.
D-Link Discover Protocol Report Timer (Seconds): Configure the report timer of D-Link Discover Protocol
in seconds. The values are 30, 60, 90, 120 or Never.
Click the Apply button to implement changes made.
DDP Port Setting:
From Port / To Port: Specifies the range of ports to be configured for D-Link Discover Protocol of the Switch.
State: Specifies to enable or disable the D-Link Discover Protocol state for the specified ports.
Click Apply to implement changes made.
System > Firmware Information
The Firmware Information page displays the information of firmware.
Figure 4.44 – System > Firmware Information
System > Configuration Information
The Configuration Information page displays the information of configuration. The user can specify which
configuration file to be viewed of the Switch.
To Next Page
Loading...
