D-Link DGS-1510/ME Series - Page 293

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
289
all - Specifies that all the ports will be used.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear DHCP IPv4 snooping entries on ports 1-3:
DGS-1510-28XMP/ME:admin# clear address_binding dhcp_snoop binding_entry ports 1-3
Command: clear address_binding dhcp_snoop binding_entry ports 1-3
Success.
DGS-1510-28XMP/ME:admin#
32-12 show address_binding dhcp_snoop
Description
This command is used to display the DHCP snooping configuration and learning database.
Format
show address_binding dhcp_snoop {max_entry {ports <portlist>}}
Parameters
max_entry - (Optional) Specifies to show the maximum number of entries per port.
ports - (Optional) Specifies the ports used for this configuration.
<portlist> - Enter a list of ports used here.
If no parameter is specified, show DHCP snooping displays the enable/disable state.
Restrictions
None.
Example
To show the DHCP snooping state:
DGS-1510-28XMP/ME:admin#show address_binding dhcp_snoop
Command: show address_binding dhcp_snoop
DHCP Snoop(IPv4) : Disabled
DGS-1510-28XMP/ME:admin#
To display DHCP snooping maximum entry configuration: