DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
346
DGS-1510-28XMP/ME:admin# config loopdetect trap both
Command: config loopdetect trap both
Success.
40-8 config loopdetect log
Description
This command is used to configure the log state for LBD. The default value is enabled.
Format
config loopdetect log state [enable | disable]
Parameters
enable - Specifies to enable the LBD log feature.
disable - Specifies to disable the LBD log feature. All LBD-related logs will not be recorded.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the log state for LBD:
DGS-1510-28XMP/ME:admin# config loopdetect log state enable
Command: config loopdetect log state enable
Success.
To Next Page
Loading...
