D-Link DGS-1510/ME Series - Page 395

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
391
45-19 clear mld_snooping statistics counter
Description
This command is used to clear MLD snooping statistics counters.
Format
clear mld _snooping statistics counter
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear MLD snooping statistics counter:
DGS-1510-28XMP/ME:admin# clear mld_snooping statistics counter
Command: clear mld_snooping statistics counter
Success.
DGS-1510-28XMP/ME:admin#
45-20 config mld_snooping rate_limit
Description
This command is used to configure the rate limit of MLD control packets that are allowed by each port or VLAN.
Format
config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> | no_limit]
Parameters
ports - Specifies a range of ports to be configured.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specifies a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list here.
<value 1-1000> - Specifies the rate limit of MLD control packets that the Switch can process on a specific port or
VLAN. The rate is specified in packet per second. The packets that exceed the limited rate will be dropped.
no_limit - Specifies the rate limit of MLD control packets that the Switch can process on a specific port or VLAN.
The rate is specified in packet per second. The packets that exceed the limited rate will be dropped. The
default setting is no_limit.