D-Link DGS-1510/ME Series - Page 396

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
392
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the MLD snooping per port rate limit:
DGS-1510-28XMP/ME:admin# config mld_snooping rate_limit ports 1 100
Command: config mld_snooping rate_limit ports 1 100
Success.
DGS-1510-28XMP/ME:admin#
45-21 show mld_snooping rate_limit
Description
This command is used to display the rate limit of MLD control packets that are allowed by each port or VLAN.
Format
show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
Parameters
ports - Specifies a list of ports.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specifies a list of VLANs.
<vlanid_list> - Enter the VLAN ID list here.
Restrictions
None.
Example
To display the MLD snooping rate limit from port 1 to 5: