D-Link DGS-1510/ME Series - Page 397

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
393
DGS-1510-28XMP/ME:admin# show mld_snooping rate_limit ports 1-5
Command: show mld_snooping rate_limit ports 1-5
Port Rate Limit
-------- ---------------
1 100
2 No Limit
3 No Limit
4 No Limit
5 No Limit
Total Entries: 5
DGS-1510-28XMP/ME:admin#
45-22 show mld_snooping host
Description
This command is used to display the MLD hosts that are joined groups on the specific port or VALN.
Format
show mld_snooping host {[vlan <vlan_name 32>| vlanid <vlanid_list> | ports <portlist> | group <ipv6addr>]}
Parameters
vlan - (Optional) Specifies the name of VLAN.
<vlan_name 32> - Enter the VLAN name.
vlanid - (Optional) Specifies the ID of VLAN.
<vlanid_list> - Enter a list of VLAN.
ports - (Optional) Specifies ports to be displayed.
<portlist> - Enter a range of ports to be displayed.
group - (Optional) Specifies the group to be displayed.
<ipaddr> - Enter the IP address of the group
Restrictions
None.
Example
To display the MLD host IP information: