D-Link DGS-1510/ME Series - Page 414

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
410
Format
config cpu_filter l3_control_pkt <portlist> [{dvmrp|pim|igmp_query |ospf | rip | vrrp} | all] state [enable |
disable]
Parameters
<portlist> - Specifies the port list to filter control packets.
dvmrp – (Optional) Specifies to filter the DVMRP control packets.
pim - (Optional) Specifies to filter the PIM control packets.
igmp_query - (Optional) Specifies to filter the IGMP query control packets.
ospf - (Optional) Specifies to filter the OSPF control packets.
rip - (Optional) Specifies to filter the RIP control packets.
vrrp - (Optional) Specifies to filter the VRRP control packets.
all - Specifies to filter all the L3 protocol control packets.
state - Specifies the filter function status. The default state is disable.
enable - Specifies to enable the filtering function.
disable - Specifies to disable the filtering function.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To filter the DVMRP control packets on ports 1 to 2:
DGS-1510-28XMP/ME:admin# config cpu_filter l3_control_pkt 1-2 dvmrp state enable
Command: config cpu_filter l3_control_pkt 1-2 dvmrp state enable
Success.
DGS-1510-28XMP/ME:admin#
47-11 show cpu_filter l3_control_pkt ports
Description
This command is used to display the L3 control packet CPU filtering state.
Format
show cpu_filter l3_control_pkt ports {<portlist>}
Parameters
<portlist> - (Optional) Specifies the port list to display the L3 control packet CPU filtering state.
Restrictions
None.