D-Link DGS-1510/ME Series - Page 475

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
471
packet if the TAG is absent, and remove the Circuit ID TAG from the received PPPoE offer and session
confirmation packet.
Format
config pppoe circuit_id_insertion ports <portlist> {state [enable | disable] | circuit_id [mac | ip | udf <string
32>]}(1)
Parameters
<portlist> - Specifies a list of ports to be configured.
state - Specifies to enable or disable port’s PPPoE circuit ID insertion function. The default setting is enable.
enable - Specifies to enable port’s PPPoE circuit ID insertion function.
disable - Specifies to disable port’s PPPoE circuit ID insertion function.
circuit_id - Specifies to configure the device ID part for encoding of the circuit ID option.
mac - Specifies to use the MAC address of the Switch to encode the circuit ID option.
ip - Specifies to use the Switch’s IP address will be used to encode the circuit ID option. This is the default.
udf - Specifies a user-defined string to be used to encode the circuit ID option.
<string 32> - Enter a string with the maximum length of 32.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable port 5 PPPoE circuit ID insertion function:
DGS-1510-28XMP/ME:admin# config pppoe circuit_id_insertion ports 5 state enable
Command: config pppoe circuit_id_insertion ports 5 state enable
Success.
DGS-1510-28XMP/ME:admin#
57-3 show pppoe circuit_id_insertion
Description
This command is used to display PPPoE circuit ID insertion status.
Format
show pppoe circuit_id_insertion
Parameters
None.
Restrictions
None.