DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
491
DGS-1510-28XMP/ME:admin# show per_queue bandwidth_control 10
Command: show per_queue bandwidth_control 10
Queue Bandwidth Control Table On Port: 10
Queue Min Rate(Kbit/sec) Max Rate(Kbit/sec)
0 640 No Limit
1 640 No Limit
2 640 No Limit
3 640 No Limit
4 No Limit No Limit
5 No Limit No Limit
6 No Limit No Limit
7 No Limit No Limit
60-5 config scheduling
Description
This command is used to configure the traffic scheduling mechanism for each CoS queue.
Format
config scheduling {ports [<portlist> | all]} <class_id 0-7> [strict | weight <value 1-127>]
Parameters
ports - (Optional) Specifies a range of ports to be configured. If not specified, all ports will be configured.
<portlist> - Enter the list of ports used for this configuration here.
all - Specifies that all the ports will be used for this configuration.
<class_id 0-7> - Enter the 8 hardware priority queues. The 8 hardware priority queues are identified by number
from 0 to 7 with the 0 queue being the lowest priority.
strict - Specifies that the queue will operate in strict mode.
weight - Specifies the weights for weighted round robin.
<value 1-127> - Enter the weights for weighted round robin value here. This value must be between 1 and
127.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the traffic scheduling CoS queue 1 to weight 25 on port 10:
To Next Page
Loading...
