D-Link DGS-1510/ME Series - Page 496

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
492
DGS-1510-28XMP/ME:admin# config scheduling ports 10 1 weight 25
Command: config scheduling ports 10 1 weight 25
Success.
DGS-1510-28XMP/ME:admin#
60-6 config scheduling_mechanism
Description
This command is used to configure the traffic scheduling mechanism for each CoS queue.
Format
config scheduling_mechanism {ports [<portlist> | all]} [strict | wrr]
Parameters
ports - (Optional) Specifies a range of ports to be configured. If not specified, all ports will be configured.
<portlist> - Enter the list of ports used for this configuration here.
all - Specifies that all the ports will be used for this configuration.
strict - Specifies that all queues operate in strict mode.
wrr - Specifies that each queue operates based on its setting.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the traffic scheduling mechanism for each CoS queue:
DGS-1510-28XMP/ME:admin# config scheduling_mechanism strict
Command: config scheduling_mechanism strict
Success.
DGS-1510-28XMP/ME:admin#
To configure the traffic scheduling mechanism for CoS queue on port 1:
DGS-1510-28XMP/ME:admin# config scheduling_mechanism ports 1 strict
Command: config scheduling_mechanism ports 1 strict
Success.
DGS-1510-28XMP/ME:admin#