DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
92
D-Link Discovery Protocol
This window is used to display and configure the D-Link Discovery Protocol (DDP) settings.
To view the following window, click Management > D-Link Discovery Protocol, as shown below:
Figure 4-84 D-Link Discovery Protocol Window
The fields that can be configured in D-Link Discovery Protocol are described below:
Parameter Description
D-Link Discovery Protocol
State
Select to globally enable or disable the DDP feature here.
Report Timer
Select the report timer value here. This is used to configure interval between
two consecutive DDP report messages. Options to choose from are 30, 60, 90,
120 seconds, or Never. Selecting Never instructs the Switch to stop sending
report messages.
Click the Apply button to accept the changes made.
The fields that can be configured in DDP Port Settings are described below:
Parameter Description
Unit Select the Switch unit that will be used for this configuration here.
From Port - To Port Select the range of ports that will be used for this configuration here.
State Select to enable or disable the DDP feature on the specified port(s) here.
Click the Apply button to accept the changes made.
SMTP Settings
This window is used to display and configure the Simple Mail Transfer Protocol (SMTP) settings.
To Next Page
Loading...
