D-Link DGS-3130 Series - SNMP Engine ID Local Settings

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
40
To view the following window, click Management > SNMP > SNMP Group Table Settings, as shown below:
Figure 4-11 SNMP Group Table Settings Window
The fields that can be configured are described below:
Parameter Description
Group Name
Enter the SNMP group name here. This name can be up to 32 characters long.
Spaces are not allowed.
Read View Name Enter the read view name that users of the group can access.
User-based Security Model Select the security model here. Options to choose from are SNMPv1,
SNMPv2c, and SNMPv3.
• SNMPv1 - Select to allow the group to use the SNMPv1 security model.
• SNMPv2c - Select to allow the group to use the SNMPv2c security model.
• SNMPv3 - Select to allow the group to use the SNMPv3 security model.
Write View Name Enter the write view name that the users of the group can access.
Security Level
When selecting SNMPv3 in the User-based Security Model drop-down list,
this option is available.
• NoAuthNoPriv - Specify that there will be no authorization and no
encryption of packets sent between the Switch and a remote SNMP
manager.
• AuthNoPriv - Specify that authorization will be required, but there will be
no encryption of packets sent between the Switch and a remote SNMP
manager.
• AuthPriv - Specify that authorization will be required, and that packets
sent between the Switch and a remote SNMP manger will be encrypted.
Notify View Name Enter the notify view name that users of the group can access. The notify view
describes the object that can be reported its status via trap packets to the group
user.
IP Address-List Name Enter the standard IP access control list (ACL) to associate with the group.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specified entry.
SNMP Engine ID Local Settings
The Engine ID is a unique identifier used for SNMPv3 implementations on the Switch.