DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
94
The fields that can be configured in Send a Test Mail to All are described below:
Parameter Description
Subject Enter the subject of the email here. This string can be up to 128 characters
long.
Content
Enter the content of the email here. This string can be up to 512 characters
long.
Click the Apply button to accept the changes made.
Click the Delete All button to delete all the entries found in the display table.
Click the Delete button to delete the specified entry.
PPPoE Circuit ID Insertion Global Settings
This window is used to display and configure the PPPoE Circuit ID Insertion Global Settings.
To view the following window, click Management > PPPoE Circuit ID Insertion Global Settings, as shown below:
Figure 4-86 PPPoE Circuit ID Insertion Global Settings Window
The fields that can be configured in PPPoE Circuit ID Insertion Global Settings are described below:
Parameter Description
Global PPPoE State Select this option to enable or disable the PPPoE Circuit ID Insertion on the
Switch. Select Disabled to disable PPPoE Circuit ID Insertion on the Switch.
Click the Apply button to accept the changes made.
The fields that can be configured in PPPoE Circuit ID Insertion Port Settings are described below:
Parameter Description
Unit Select the stacking unit ID of the Switch that will be configured here.
From Port - To Port Select the range of ports that will be used for this configuration here.
State Select to enable or disable the PPPoE Circuit ID Insertion Port state here.
Circuit ID Type Specifies that the IP, MAC, or expert UDF format will be used.
Click the Apply button to accept the changes made.
To Next Page
Loading...
