DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
402
Parameter Description
Value Enter the threshold value. This value must be between 0 and 131 mA.
Click the Apply button to accept the changes made.
DDM TX Power Threshold Settings
This window is used to display and configure the threshold of TX power for specific ports on the Switch.
To view the following window, click OAM > DDM > DDM TX Power Threshold Settings, as shown below:
Figure 10-271 DDM TX Power Threshold Settings Window
The fields that can be configured are described below:
Parameter Description
Unit Select the Switch unit that will be used for this configuration here.
Port Select the port used for the configuration here.
Action Select the action that will be taken here. Options to choose from are Add and
Delete.
Type
Select the type of TX power threshold. Options to choose from are Low Alarm,
Low Warning, High Alarm, and High Warning.
Power Unit Select the power unit here. Options to choose from are mW and dBm.
Value Enter the threshold value either in mW or dBm here.
• When selecting mW in the Power Unit drop-down list, this value must be
between 0 and 6.5535.
• When selecting dBm in the Power Unit drop-down list, this value must be
between -40 and 8.1647.
Click the Apply button to accept the changes made.
DDM RX Power Threshold Settings
This window is used to display and configure the threshold of RX power for specific ports on the Switch.
To view the following window, click OAM > DDM > DDM RX Power Threshold Settings, as shown below:
To Next Page
Loading...
