DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
221
Parameter Description
metrics don't convert directly, using a default metric provides a reasonable
substitute and enables the redistribution to proceed.
Type Select the distance type here. Options to choose from are Intra-Area, Inter-
Area, External-1 and External-2.
• Intra-Area - Specifies the distance for OSPF intra-area routes.
• Inter-Area - Specifies the distance for OSPF inter-area routes.
• External-1 - Specifies the distance for OSPF external type-1 routes.
• External-2 - Specifies the distance for OSPF external type-2 routes.
Distance Enter the distance value for the OSPF process here. The range is from 1 to
254. By default, this value is 110 for all OSPF routes.
Auto Bandwidth
Enter the auto-bandwidth value here. This feature is used to control the
reference value IPv6 OSPF uses when calculating metrics for interfaces. The
range is from 1 to 4294967.
Click the Apply button to accept the changes made.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Show Detail in the table, the following page will appear.
Figure 6-55 OSPFv3 Process Settings (Show Detail) Window
Click the OK button to close the window and return to the previous window.
OSPFv3 Passive Interface Settings
This window is used to display and configure the OSPFv3 passive interface settings. If an interface is passive, the
OSPF routing update packets are not sent or received through the specified interface.
To Next Page
Loading...
