DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
344
Figure 9-615 IPv6 Source Guard Settings Window
The fields that can be configured are described below:
Parameter Description
Policy Name Enter the policy name here. This name can be up to 32 characters long.
Global Auto-Configure
Address
Select to permit of deny data traffic from the auto-configured global address. It
is useful when all global addresses on a link are assigned by DHCP and the
administrator that wants to block hosts with self-configured addresses from
sending traffic.
Link Local Traffic Select to permit of deny hardware permitted data traffic send by the link-local
address.
Validate Address
Select to enable or disable the validate address feature here. This is used to
enable the IPv6 source guard to perform the validate address feature.
Validate Prefix Select to enable or disable the validate prefix feature here. This is used to
enable the IPv6 source guard to perform the IPv6 prefix-guard operation.
Target Port Tick this option to specify the target port.
Unit Select the Switch unit that will be used for this configuration here.
From Port - To Port Select the appropriate port range used for the configuration here.
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specified entry.
IPv6 Neighbor Binding
This window is used to display and configure the IPv6 neighbor binding settings.
To view the following window, click Security > IMPB > IPv6 > IPv6 Source Guard > IPv6 Neighbor Binding, as
shown below:
To Next Page
Loading...
