DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
60
Click the Configure button to configure the DHCPv6 server pool settings.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Configure button, the following page will appear.
Figure 4-40 DHCPv6 Server Pool Settings (Configure) Window
The fields that can be configured in DHCPv6 Server Pool Configure are described below:
Parameter Description
Address Prefix
Select and enter the DHCPv6 server pool IPv6 network address and prefix
length here. For example, 2015::0/64.
Valid Lifetime Enter the valid lifetime value here. The range is from 60 to 4294967295
seconds. The valid lifetime should be greater than preferred lifetime. If this
value is not specified, then the default valid lifetime will be 2592000 seconds
(30 days).
Preferred Lifetime Enter the preferred lifetime value here. The range is from 60 to 4294967295
seconds. If this value is not specified, then the default preferred lifetime will be
604800 seconds (7 days).
DNS Server Enter the DNS server IPv6 address to be assigned to requesting DHCPv6
clients here.
Domain Name Enter the domain name to be assigned to requesting DHCPv6 clients here.
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
The fields that can be configured in Static Bindings are described below:
Parameter Description
Static Bindings Address Enter the static binding IPv6 address assign to the specific client here.
Client DUID Enter the client DHCP Unique Identifier (DUID) here. This string can be up to
28 characters long.
IAID
Enter the Identity Association Identifier (IAID) here. The IAID here uniquely
identifies a collection of non-temporary addresses (IANA) assigned on the
client.
To Next Page
Loading...
